From Alex:
IONPC:EQU=...,IP=...;
or
IONPC:EQU=[IP],[MASK],[GATE];
The command is used to change the network configuration of a physical I/O port on the NIU/NIU2. The network configuration must be changed prior to using IOEQI to initiate a logical network port. Only the parameters that get a new value will be changed, other parameters will keep their existing values.
Once the network port configuration is defined it can be reset by specifying IP equal to NONE. The IP address of the I/O port, the IP address of default gateway, and the address mask will be reset to default values indicating that the network port configuration has not been set.
EXAMPLE 1
Change IP address of the Ethernet port at position 1-0-23-4 to 204.94.208.0.
< IONPC :EQU=1-0-23-4,IP=204.94.208.0;
EXECUTED
IONCP; to printout IP settings
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.