Change from Analog to T1 - PRI.

[Dmacnumberfour]

Hello,
We have an MICS that we are moving for a customer. They have analog lines going into it now, set up in a linepool.
They are getting DID lines off the T1 at the new location. I would like to know the steps for setting up the DID's off a T1. I know something about doing the key codes, but don't know how to do that part? Also is it similar to setting up analog DID's? Thanks for the help.
Dmacnumberfour,

 

[jeter]

NO keycodes are needed. The DTI card will need to be setup in 1 of the 2 slots in the 0x32 so you will be using lines 1-24 or 25-48. the DID programming will remain the same setup target lines. If a PRI is needed than you will need a keycode!!! Jeter@LasVegas.com
Fisher CCNA
Sprint-Data

 

[Dmacnumberfour]

Jeter,
Thanks for the help. I'll have to get more info. Not sure if PRI is needed in this situation.
Dmacnumberfour,