Challenge VOIP as5300

[ealan]

We have few technicians that R working from home
We want them to connect through netmeeting to our as5300
And through there to our offices in the world

We configured the as5300 like that:

voice class codec 1
codec preference 1 g723r63
codec preference 2 g723ar63
codec preference 3 g723r53
codec preference 4 g723ar53
codec preference 5 g711ulaw
codec preference 6 g711alaw
!
voice class h323 2
call start slow
!
voice-port 1
cptone GB
bearer-cap Speech
!
voice-port 2
cptone GB
bearer-cap Speech
!
dial-peer voice 151 pots
preference 1
destination-pattern .T
direct-inward-dial
port 1
no register e164
!
dial-peer voice 152 pots
preference 1
destination-pattern .T
direct-inward-dial
port 2
!
dial-peer voice 153 voip
destination-pattern 044T
voice-class h323 2
session target ipv4:A.B.C.D (the incoming IP)
voice-class codec 1
fax rate disable
no vad
!
dial-peer voice 154 voip
destination-pattern 044T
session target ipv4:A.B.C.D
voice-class codec 1
fax rate disable
no vad
!
dial-peer voice 155 voip
destination-pattern 044T
session target ipv4:A.B.C.D
voice-class codec 1
no vad
!
dial-peer voice 156 voip
destination-pattern 044T
session target ipv4:A.B.C.D
voice-class codec 1
!

What we receive is the phone is ringing but the netmeeting user can not hear it
When the office answers both side can not hear each other

The dial peer above are the all option that we can think about

Our IOS is 12.2.5T

I hope some one has an answer

TNX for your help

Ealan

 

[frizTU]

Ealan, I was wondering if you could help me with your router configuration with netmeeting. I have a cisco 3745 multiservice access router. I am trying to connect an analog phone into the voice port of the router and then connect the FastEthernet port into a hub. From my computer, I am trying to use netmeeting through my NIC that goes into my hub. I was wondering if you can inform me of how I can go about doing this, even if it is only going to ring. Thanks for the help.
-Friz