CellPipe 50AS Nat/Firewall

[rdebourbon]

Hi,

I need to setup my Lucent Cellpipe 50AS for use with a seperate firewall (for ease of config). I need to disable the builtin firewall - it is enabled and I dont want to have to forward each port seperately... My IP is dynamically assigned by my ISP, and I have NAT enabled on the firewall... What is the best way to do this?

Thanks in advance

Rdebourbon

 

[MaxPipeline]

If you are referring to NAT as the "builtin firewall" then you will not be able to disble this with a dynamic address assignment. The cellpipe needs to perform PPP to obtain the IP address assignment. But in order to even be able to accept a dynamic address the Cellpipe needs to run NAT.

I should add that I do not work with Lucent DSL products, but my understanding is the Cellpipe is similar in configuration to all other Lucent Pipelines. So unless there is a feature on the Cellpipe to act as a modem only I think you will not be able to disable NAT.