Cell Station Setup

[quazimotto]

Greetings All,

I have a KX-TDE 200 that I would like to set-up a DECT Cell Station with a KX-T7685 handset. I used an unused DLC-16. On the amphenol, I skipped the first pair ( white/blue), used the second and third pairs ( orange/whites--green/whites ) and used a four conductor satin cord to connect to the PBX. When I use Utility- CS Information, it says in-service and all 8 paths are off. Utility-CS_Status-Monitor, it states ports 5,1 and 9 on physical card 4 have faults and port 2 is in service. Makes me think I have it wired incorrectly. What do you guys think? All comments appreciated.

Thanks,
Quaz

 

[raoul008]

Did you use a kxttda0156 (4port )cell station because you need a csif physical card

If a 0155 or 0158 they can be plug to and dlc no need to skip port in the dlc 16 1 port for the 0155 and 4 port for the 0158 are use

 

[EMJP]

analog extensions are to be wired in position 2/3 on RJ11, 4/5 on RJ45,
digital extensions are to be wired in position 1/4 on RJ11, 3/6 on RJ45 (CS are digital extensions)
Amphenol DLC16
CS TDA0155 only need one pair to work (on the RJ11 position 1 and 4 are to be connected)
The Amphenol cable, you must use the first 16 pairs if you want to connect 16 DECT antennas, so pairs 1 to 16
CS TDA0158 need 2 pair:
RJ45 in the TDA0158 : pair 1: 4/5 pair 2: 3/6

Installation manual : PSW = 2ufrompanasonic
DLC16 P.64

 

[quazimotto]

EMJP,

I appreciate the comeback and information. Can you point me to the information on how to program the antenna and sync a phone to it, please?

Thanks again.
Quaz