Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
CDR connection off a CS1000M Single Group
- Thread starter joebacon
- Start date
1, 3 and 7 normally - although some PBXs do need different pin conditions. Don't wire Pin 2 as you don't want to be sending anything back to the PBX.
For very high quality cabling and up to a maximum of 9600 baud yep 150ft is your limit, on bog standard cabling you're looking more like 50ft. That's a lot of serial cable though! You could use line drivers to boost the signal but to be honest they're flaky. Consider Serial->IP convertors or putting it over modem.
For very high quality cabling and up to a maximum of 9600 baud yep 150ft is your limit, on bog standard cabling you're looking more like 50ft. That's a lot of serial cable though! You could use line drivers to boost the signal but to be honest they're flaky. Consider Serial->IP convertors or putting it over modem.
brewerdude
IS-IT--Management
CS1000M single group, that's an Option 61C isn't it?? 
If you need to get your CDR a great distance, you may want to look into acquiring a buffer box and getting your CDR over the network. Omnitronix makes a lot of products that can help you here.
If you need to get your CDR a great distance, you may want to look into acquiring a buffer box and getting your CDR over the network. Omnitronix makes a lot of products that can help you here.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
