CDR-Access code issue

[lapakhora]

HI i have made a RLI having two entries ENTR 0 and ENTR 1. ENTR0 include route 1 and ENTR1 include route 2. AC2 is set to 9 for outbound dialing. This setup is working fine when route1 get down call goes through route2. In output CDR data access codes always show 9 whether calls are going through route1 or route 2. I need that the CDR must show the original access code of the route calls are going through.
any help??

 

[AvayaHE]

Your details are a bit limited but these solutions below are from the CDR Fundamentals
This will allow you to show the trunk access code or not


Table 139: NARS calls
Digits dialed: ESN or ISDN Access Code + Location Code + extension OPD option used Digits recorded in CDR OPD = NO Actual digits dialed
OPD = YES (the call stays in the ESN or ISDN network)
ESN or ISDN Access Code + Location Code + outpulsed digits
OPD = YES (the call overflows to the public network)
ESN or ISDN Access Code + Trunk Access Code + outpulsed digits

Table 140: All other NARS calls
Digits dialed: ESN or ISDN Access Code + digits OPD option used Digits recorded in CDR OPD = NO Actual digits dialed
OPD = YES ESN or ISDN Access Code + Trunk Access Code + outpulsed digits
Table 141: CDP calls with OPD and CDPR option
Digits dialed: ESN or ISDN Access Code + digits OPD option used Digits recorded in CDR OPD = NO CDPR = NO ESN or ISDN Access Code
CDPR = YES ESN or ISDN Access Code + Trunk Access Code
OPD = YES ESN or ISDN Access Code + Trunk Access Code + outpulsed digits

 

[lapakhora]

Hi PAL, What else information you required please.

Regards