CCS trace commands

[Tony800]

I regularly use CCS trace enable continuous to monitor message blocks when tracing calls. I have used CCS trace set context <PLID> for specific channel testing.
Sometimes I need to monitor a complete hybrid of 30 channels, does anyone know if there is a set context command to enable more than one channel without running continous
I am using Mitel SX2000 lite
Operating with MS2009-F-UK-00 Edition SX.Q23.2.5

 

[Supernova99]

You can add as may channels as your link supports just keep adding each channel using context or you can just do everything CCS TR EN CONT

Share what you know - Learn what you don't

 

[Tony800]

Thanks Supernova99 I'll give it a try I guess I was looking for a way to do all 30 channels on a CEPT card hybrid without putting them in one at a time. I do use ccs tr en cont but one of the switches is set up as a transit and gets pretty busy at times so it takes a bit of time to filter bits I do not need.

 

[Supernova99]

You will need to add all 30 channels of an individual link one at a time using the context command there is no other way unfortunately.

Share what you know - Learn what you don't