Connect to console <br>Unplug power<br>Hold in on the Mode button at the same time you plug the power back in<br>Release the button a second or two after port 1x led lights<br>enter flash_init at the switch: <br>enter load_helper at the switch: <br>enter dir flash: at the switch: <br>Rename the config.text file to config.text.old<br> ren flash:config.txt flash:config.text.old<br>enter boot at the Switch:<br>Continue with configuration dialog answer no<br>When it loads go to enable mode<br>rename the config.text.old to config.text<br>copy flash:config.text system:running-config<br>conf t<br>enable pass (password)<br>copy runn start<br><br>Just so you know this is form the 2900 series Installation and config guide.<br><br>Let me know if this helps<br>Rob Brown
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.