CAP Installation 1

[tcwinont]

Thanks in advance for any help or comments.

I've trying to install a single CAP on a 7324. I've read on some of the threads on this forum and just want to verify this.

Do I need the SAP for this or can I have 24v on the extension to power the CAP? I've plugged it into the 7324 with a 6-wire conductor cable from the jack to the CAP and then a 4-wire conductor cable from the CAP to the 7324. The CAP doesn't respond (flash) but the 7324 works fine. I've tried switch the 6 & 4 conductor cables but no dice. Your comments are appreciated.

TCWINONT

 

[luv2ski]

what does the documentation say

Pat Guido
NEXTIRAONE
Pat.guido@nextiraone.com

Formerly Nextira, formerly Williams Communications, formerly Wiltel, formerly Nortel networks, formerly Northern Telecom, formerly, Nynex meridian systems formerly Northern Telecom.

 

[Dmacnumberfour]

tcwinot,

This off the FAQ section of this forum.

WIRING:

The Norstar KLM needs an external power source. A way of providing this source is by wiring in the VP324 24-volt DC power supply. In this example a 6 conductor modular jack is being used. The power supply can power 2 KLMs. To connect second KLM you will add another power pair to the 3rd pair on the 6 conductor modular jack. You can have a maximum of 5 CAPs(10 KLMs) “central answering positions” per system. The CAP can only be a 7324 and you can attach 2 KLMs to the 7324.

1st KLM Power Pair
pin 5 Yellow -24 V
pin 2 Black Gnd

2nd KLM Power Pair
Pin 6 Blue -24 V
Pin 1 White Gnd



PROGRAMMING:

1. Have the CAP modules attached to the telephone with power supplied.
2. Enter SYSTEM PROGRAMMING
3. Select SHOW and then select NEXT to CAP ASSIGNMENT
4. Select SHOW
5. Cap1:none is displayed, select CHANGE
6. Cap1: xxx, enter the extension number of the CAP with one or two KLMs attached.
7. Exit programming