Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

CANWPABD.NLM: EA000: Failed Host Adapter Initialization. 1

Status
Not open for further replies.

pakilaci

IS-IT--Management
Jan 21, 2005
57
HU
Netware 6.0 SP5, Bab 11.1 NW (patched), Adaptec 2120S Scsi, 3x Seagate ST1181677LCV HD, Raid0. No tape device connected, would like backup to File System Dev. Unable to start Arcserve. Please, any ideas!

May-09 14:24:05 CANWPABD: BINDING : ADAPTER [AACRAID.HAM] / [1] DEVICES
May-09 14:24:06 CANWPABD: DEVICE[0] : /[V317-A1-D0:0] ADAPTEC RAID Device
0:00 rev:1.0 Not Registered
May-09 14:24:06 CANWPABD:
********************************************************
May-09 14:24:07 CANWPABD: Searching for valid Adapters, Please wait.
May-09 14:24:07 CANWPABD: No valid adapters found...Unloading.
May-09 14:24:08 BrightStor ARCserve r11.1 SCSI CDM Device Driver (Build
753.000 06/21/04)
May-09 14:24:08 r11.10 June 21, 2004
May-09 14:24:13 CANWPABD.NLM: EA000: Failed Host Adapter Initialization.
May-09 14:24:13 CANWPABD.NLM reported a critical error. No more modules
will be loaded.
May-09 14:24:14 CANWPABD.NLM SCSI board driver has been unloaded.
 
Its looking for a tape drive and not finding it fails.

Uninstall, reinstall, when asked for a controller say none. Then it will not look for a tape drive.
 
Thank you very much, Davidmichel! It was a big help for me, problem solved.
icon_smile.gif
 
I am getting the same message... unfortunately there is an internal SCSI tape drive...
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top