Can't view ZIP Drive on NT Terminal Server.

[yamcha]

I was installing the IomegaWare and i can't view my ZIP Unit.
That software is the only one in the ZIP-Site.
Some Body knows where can i find another site with drivers
for NT Terminal server ?
I am running on Service Pack6 for NT Terminal Server, and my Zip Unit is 100 Mb.

 

[De8o]

If it is an external zip drive connected to the parallel port it could be that this is incorrectly set in the bios. Change the setting for this port in the bios, I think there are three possible modes and see if the server can see the zip drive then.
Darren

 

[skimmilk]

I'm not that familiar with Terminal Server but I have found with NT4.0 (Server) that it is required that you actually have a zip disk installed into the drive for it to be installed and labeled (drive letter) correctly. This is not 100% of the time, but through personal experience I would say 75%.
Good Luck

 

[CitrixEngineer]

Are you attaching the Zip drive to the Terminal server or to a client PC?

Is it internal or external?

If external and on the client, you will need to remap the parallel port via a net use command.

If on the server, how are you trying to view the drive? At the console or via a session?

Did you install the Iomegaware in change user /install mode?

Do you KNOW this software works with Terminal Server?

If not, always assume it probably won't and TEST off line.

I hope some of this helps!

 

[yamcha]

Thanks a lot Everyone !!

Yes, my Zip is External, an was installed for exclusive
mode.
I was checking the port Configuration and it's Ok.

You said i need use the NET command, what is the command
line that i must to run?

Thank you very much !!!