First, this is not my licensed IPSI, I am testing for our stock shelf. I am running CM 4. I have configured the IPSI with the correct IP address for the control network, pinged and confirmed ip communciation and traffic with on network devices inclding pinging from shell on my S8710. through the web interface I have upgraded and down-graded the firmware. The maintenance interface will see the board and give me correct board ID, HW and FW versions.
But when I do a list con boa from ASA I get board not inserted. Same when I am doing a test ipserver-interface 01A. Same config as my licensed IPSI and others I tested in the past. Any Ideasi
Thank you for you time and ideas.
But when I do a list con boa from ASA I get board not inserted. Same when I am doing a test ipserver-interface 01A. Same config as my licensed IPSI and others I tested in the past. Any Ideasi
Thank you for you time and ideas.