Can't see catalyst 2950 switch in RME inventory??!!

[michoco]

I can't see catalyst 2950 switch in RME inventory...i see it as an unkown device...what could be the problem???

 

[margny]

Hello Michoco
Excuse I but my English is not very good
Look if you has the check package for this catalyst?

In: Device Manager\Administration

Cat2950 6.0 Cat2950 Device Package

 

[vipergg]

This is probably a Ciscoworks version issue , we have seen the same thing with 2950 and the new 4500 IOS boxes . These show up as other or unknown . Apparently this is taken care of in the newer versions .

 

[pflakes]

I've been working on the same issue with 4500s and 3640s. The response I got from Cisco was to try one of 2 things. The first of course is their initial response to everything -- reboot.

The other was to remove the snmp-server config, write to memory and then readd the snmp config. This didn't work for me but it might for you.

My TAC case is still open but I'll return to this posting if we do come up with a solution.

Good luck!


TAC Case -- CSCea67346
When you add a GSR device to RME, it may appear in the Not Responding state.
This happens only if the processor RAM of the device is greater than or equal to 2 GB.

Workaround:

None.