Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Can't make international 00 outbound calls ...!!

Status
Not open for further replies.

Optman

Technical User
Apr 14, 2011
528
MA
Hi all

we have built new AC1 NARS/BARS routing with Opt11c System (PRI Trunk), all work good except international, when we use the ACOD of the RDB the call to international number is working...but when we use AC1 + SPN (00) NARS/BARS the international calls don't work..!!!

Please what can be the cause of this problem...?

Thanks

Regards
 
look at NCOS settings

Remember if it doesn't work hit it harder

Scott UK
 
or spn going via DMI what does the DCh msging say? is it getting that far?

Remember if it doesn't work hit it harder

Scott UK
 
I have check for the NCOS and DMI all is good...but I have the same issue of calling international..when we try through ACOD it work fine however through AC1 NARS/BARS not working....!!!

please any help..?
 
yes the BARS is configured to the correct route,
TGAR 2 and TARG 1 2 (the user use authcodes to override TGAR/TARG)
NCOS 2 (alow all).
RLI with FRL (2 mapped to the NCOS 2)

Release software 4.0

thanks
 
What type CO. switch are you going to (MI2, DMS100, ESS5 ect...)?

Don6531
 
What "flen" length are you using?. Try changing it to "0" on the SPN.

Using the guide and tool that I've done for collecting your ESN data to check it's all there correctly.


All the best

Firebird Scrambler
Meridian 1 / Succession and BCM / Norstar Programmer in the UK

If it's working, then leave it alone!.
 
Check DMI CTYP(Call Type)Thats another area you might wanna check

Cheers!!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top