Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Can't initialize Spell Assist 1

Status
Not open for further replies.

Rev

Programmer
May 7, 1998
41
AM
I am using Draw8 rev.B When I go to type I get an error message that says "Can't Initialize Spell Assist" I have reinstalled the program and I have also tried reinstalling the writing tools only. I followed Microsoft's tip on repairing a corrupted font registry and that didn't work either. I remember once having to delete the font registry and rebuilding it, but I don't remember how. Does anyone know how, or what else may be causing this problem?
 
This is a shot in the dark.....<br>
<br>
Are you running Draw from a network server? I am and have encountered the same problem. Our tech. department hasn't tested properly for this yet but the assumtion is that for Spell Assist to work, the program must be installed and run from a local drive.<br>
<br>
I would be very interested to know the solution to this problem. It has been a headache for us as well.
 
This is a problem with the CorelDRAW install routine on some computers. I know how to fix it -- it's very simple. If you e-mail me I will reply with all the necessary information.<br>
<br>
Regards,<br>
<br>
Nick.<br>
n.wilkinson-at-btinternet.com
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top