Hey All
I've installed the CCI HORCM software onto an AIX 5.3 system. I've run the "horcminstall.sh" script that came on the CD, but when I get to the horcm1.conf and horcm0.conf files to configure them for my system, I can't figure out where to get the LU in the config files. Any ideas on how I can go about finding them? Below is a snippet from my horcm0.conf
#/************************** For HORCM_DEV ************************************/
HORCM_DEV
#dev_group dev_name port# TargetID LU# MU#
sybdevcopy ldev-102-103 CL7-E-0 0 259 0
sybdevcopy ldev-102-105 CL7-E-0 0 261 0
#VG02 oradb2 CL1-A 1 1 0
Thanks
I've installed the CCI HORCM software onto an AIX 5.3 system. I've run the "horcminstall.sh" script that came on the CD, but when I get to the horcm1.conf and horcm0.conf files to configure them for my system, I can't figure out where to get the LU in the config files. Any ideas on how I can go about finding them? Below is a snippet from my horcm0.conf
#/************************** For HORCM_DEV ************************************/
HORCM_DEV
#dev_group dev_name port# TargetID LU# MU#
sybdevcopy ldev-102-103 CL7-E-0 0 259 0
sybdevcopy ldev-102-105 CL7-E-0 0 261 0
#VG02 oradb2 CL1-A 1 1 0
Thanks