Can't get 1140E phones to work on BCM50E 1

[perknal]

I have a BCM50E s/w 6.0.2.05.237 (not sure what this means as I`m pretty sure I upgraded it to 3.0).
IP Subsystem as follows:
Obtain IP address dynamically - No
IP address: 192.168.1.2
IP subnet mask: 255.255.255.0
Default gateway: 192.168.1.1
The system also has 8 IP set licenses.

Telephony Resources:
IP Terminal Global Settings:
Enable registration - checked
Auto-assign DNs - checked
Default codec - Auto
Default jitter buffer - Auto

How do I need to program the 1140E sets under Network Configuration to get them to work on this BCM? And is there anything I need to do through the OAM programming. Thanks

 

[Dasheen]

assign an ip to the set and assign ip to s1 or set to dhcp if using a dhcp server.

 

[perknal]

Thanks for getting back to me. I programmed the set as follows:
DHCP: Partial
Set IP: 192.168.1.101 (can't be changed unless I change DHCP to No)
NET MASK: 255.255.255.0 (can't be changed unless I change DHCP to No)
Gateway: 192.168.1.1 (can't be changed unless I change DHCP to No)
S1 IP: 192.168.1.8
Port: 7000
S2 IP: 192.168.1.8
Port: 7000

When I apply/restart the telephone after NORTEL is displayed I get the following:
Waiting for Cfg Data..., then
Couldn't identify switch, then
F/W Version 0625C23
Starting DHCP...

It then sits there and does not come up.
Appreciate any suggestions.

 

[cook1082]

If this is on your network then you have to put the BCM on it with a static IP address.

 

[Dasheen]

S1 and S2 need to be the bcm ip address. Without it the phones will never connect.

 

[perknal]

Thanks very much! Sets are working.