Can't established call using analog trunk connection to cisco router

[drl1116]

Hi,

I'm using CS1000 5.5 and I interconnect my system to a cisco router to call outside via DXUT card. When I dial the access code I was able to get dial tone but after that, silence. I traced the extension I used to call and I got this;
KEY 0 SCR MARP ACTIVE TN 004 0 04 14 IPMG 004 0

ORIG TN 004 0 04 14 IPMG 004 0 KEY 0 SCR MARP CUST 0 DN 213 TYPE 3902
TERM TN 004 0 08 00 IPMG 004 0 V PHYSICAL TN 000 0 00 00 COT RMBR 60 1 OUTGOING TRUNK CALL
DIAL DN 9338106
MAIN_PM DIAL AUX_PM DDL
TALKSLOT ORIG 21 TERM 21
EES_DATA:
NONE
QUEU NONE
CALL ID 0 17094


Does anyone who could tell what/where the problem is?

Thanks in advance

 

[drl1116]

It look like I'm missing some configuration which provide signaling to complete the outpusing of digits..

Appreciate if someone could give me idea on this...I'm in the middle of the sea and don't have available spares for isolation..

Thanks