Can't Dial-in to make admin changes anymore 1

[BSchmidtNSSL]

Our phone system will no longer output information to a remote terminal. We can dial the modem and connect, but then it just sits there. I have changed modems, cables, nothing seems to work. I can still login through the terminal directly connected and it works fine. Any suggestions?

 

[PERRYPJ]

CHECK IN LD 37 TO SEE IF THE TTY IS DISABLED

OLD ROLMEN WORKING ON NORTELS

 

[acewarlock]

I have had this problem a few times this week, what I found was in procomm I had hit the Start/Stop Script button by mistake. it drove me crazy till I figured it out. Also last week I had to reset the PBX modem once. Hope this helps.

 

[BSchmidtNSSL]

PerryPJ,
Thanks for the very quick help. TTY 3 was disabled, the only thing I can think of is a storm rolled through and knocked our lightning detect network out and maybe this too. Thanks for the help.

 

[vvhitekid2]

Would somebody be able to provide specifics on doing this? I have a feeling this is the problem with one of our switches, and do not have documentation on LD 37. Or perhaps point me in the right direction as to where I can find good documentation (I couldn't find it on nortel's site).

Thanks in advance-
Dave

 

[rookie10]

LD 37
STAT (List all TTY ports)
ENL TTY X (Enable TTY Ports)

 

[vvhitekid2]

Thanks rookie... just what I was looking for.

Dave

 

[BMiles2000]

On another note, You will want to make sure the modem is in dumb mode and set to no echo. Or your TTY port will keep disabling. I personally use US robotics modems (work the best) and use the following command string.


AT&B1&W&W1

Good Luck!