Can't change MODE parameter for OPI

[siouxes]

I am trying to modify MODE parameter for Operator. The strange behaviour is that: i enter command OPISSIR=XXXX,MODE=0; (previous i had MODE=1). After some handled calls, if i enter OPISPIR=XXXX; I get MODE=1 !!! Obviusly, exchange didn't perform any data reload in the mean time...

I have tried with OPI in absent state, with exchange night switched, i have tried restarting OLP1T and OLP1D but nothing...

I have tried on a lab system and fault doesn't occurs.

Any suggest?

 

[thedayaftertomorrow]

Hi
OPEREIR=XXX;
ASPACARNUM=30,PARVAL=1;
OPERIIR=XXX,MODE=1,......;
OPCGS;

 

[siouxes]

I have tried it before open the thread...

 

[VMPOP]

what's the type of the OPI console you use,

 

[siouxes]

OPI-II...

 

[VMPOP]

hello use only this command after
OPEREIR=XX;
N.B. DID THE OPERI REMOVED HERE?
THEN:
OPERIIR=XX,EQU=X-X-XX-X,PRG=0,OPC=11111,TRAF=1515,OCUST=X,MODE=1,
TYPE=5,PCM=1,TRM=1;
OPCGS;

IF IT DOESN'T WORK TRY RESUBMIT OLP1T and OLP1D AGAIN.

USE CLEAN INL X.D X.P DATA.