cannot see the exaxct capacity of the logical drive on istalation

[demetrio]

Installing sco 5.07 on an ml 370 g4 server i can not see the exact capacity of the disk in order to continue my installation
I have an Ml server, a 641 raid controler ,two 300 gb hd, and a dlt tape
I did the following steps..
I create the logical drive (raid 0+1 in my case) and i can see it as the system boots
i create the driver of the controler and in boot(from my cdrom) i wrote
defbootstr link=ciss hd=Sdsk Sdsk=ciss(0,0,0,0)
When i asked i 'told' to read from the diskette and then "r" to replace
As it continues i saw that it has recognized the raid contoler and the logical drive that i have created ,but as soon i try to customize the disk and create the partions the capacity i get has nothing to do whith the whole capacity of the logical drive (it is much lesser)
Did i miss something ? or did i do anything wrong?
any help would be greatfull..

one other thing.. i have attached the dlt to the controler of the board.. Will the system automatically recognize it ? Or is one of the drivers in the diskettes that i had created..I think it is ad160..or maby not

Tnank you in advance

 

[motoslide]

Did you review this article?

http://h200003.www2.hp.com/bizsuppo...1&prodTypeId=15351&objectID=PSD_EU041208_CW01

It basically says you need to recreate the Logical drive using the BIOS-utility instead of the Array Configuration Utility (CD or Floppy utility).



"Proof that there is intelligent life in Oregon. Well, Life anyway.

 

[demetrio]

Thank you..