I'm using a cisco 2610. Recently upgraded the RAM from 24 to 32mb and did a reload/upgrade on the IOS to 12.2. When I make any changes at the config prompt such as ethernet interface changes, router name changes etc, I then do a "copy run start" to save. After I do a reload it puts me immediately into auto config, when I exit out I see that none of my changes took to the startup-config. Thank You in advance for any suggestions.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Cannot read startup-config from NVRAM CISCO 2600
- Thread starter tester100
- Start date
- Status