Cannot ping my Own Interface...

[Guest_imported]

I have a Cisco 2611 setup with a Frame relay sitting on serial 0 that connects to a remote network. While im in the router I cannot even ping the IP address of the Serial interface... Is there a trick to this one I dont know about? The line is Up/Up and the PVC is active on both ends.

Any ideas?

 

[jeter]

Is there a problem with the circuit or any routing issues?
Can you ping the far end serial address? Jeter@LasVegas.com
Fisher CCNA
Sprint-Data

 

[dasmit]

You cannot ping your own interface with Fram, cause and ICMP echo has to be sent back.

http://www.cisco.com/warp/public/116/fr_faq.html

Look at the first anwsered question.

-Dave
CCNA

 

[KSM]

How do you configure serial interface in router? with subinterface or not? point to point or multipoint? Do you see any routing protocol neighboring routers?