I am using egate 4.5.3 and I am new to this development software although I have over 30 years of programming experience.
My project is to take a | delimited file from an external system and convert it to HL7 to send out to another external system. My eway uses stceway.exe and the application will read my external connector and print the external server,ip address, directory that contains the file and the file name and then it reads 70 bytes that it calls a heading from somewhere and then does not find anything else to read. It appears to not read further and then repeats the procedure.
What do I need to change to get it to read my file?
Thanks,
rtillery
My project is to take a | delimited file from an external system and convert it to HL7 to send out to another external system. My eway uses stceway.exe and the application will read my external connector and print the external server,ip address, directory that contains the file and the file name and then it reads 70 bytes that it calls a heading from somewhere and then does not find anything else to read. It appears to not read further and then repeats the procedure.
What do I need to change to get it to read my file?
Thanks,
rtillery