Old Merlin Legend, just switched from a T1 with 20 Loop-Start trunks to a PRI. Inbound seems to be working fine, but I cannot seem to send 10 digits (required for local calling in Denver) outbound. 7 work fine, but when I adda an ARS table & CBC pattern to add 720 or 303, all it sends is the area code, not the entire 10 digit number. 10 digit worked fine with old t1, PRI having serious trouble!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Cannot dial 10 digits out on new PRI
- Thread starter dataplaya
- Start date
Unless your PRI tables are goofed, then go to Telco, and verify wha they see when you dial a 10 digit number. If they can't see the 1, it's you, if they can see it, but can't route it, then it's them. You may want to try stripping the 1 from the LD ARS table. If that works, it means that Telco doesn't want to see the 1, and gets confused when they do. That's probably the problem, since things are OK on 7 digits.
Pepperz@charter.net
Pepperz@charter.net
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question