Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cannot connect 2 3com 3300's via x-over cable

Status
Not open for further replies.
Guest_imported

Guest_imported

New member
Jan 1, 1970
0
I cannot get a led light from either switch when I try to stack them via crossover cable. I have the cable plugged in right ports. I get lights with the workstations on both switches. Any suggestions?
 
Sort by date Sort by votes
As far as I know, you can use a straight-through cable. One end goes into any open port on your active switch and the other end goes into the uplink port on the second switch.

Hope this helps.

Ethertec
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

bengi1234
  • Locked
  • Question
Replacement/Repair HP 2900 Series Switches 1
Replies
2
Views
160
bengi1234
bengi1234
starmanjl
  • Locked
  • Question
Can someone direct me to some docum
Replies
1
Views
137
meneerB
meneerB
Siopao
  • Locked
  • Question
Watchguard XTM, HP 2920 PoE, and Cisco SG300-20
Replies
0
Views
97
Siopao
Siopao
AlphaMann
  • Locked
  • Question
Enabling DSCP 46 bit set priorization
Replies
0
Views
118
AlphaMann
AlphaMann
NYCCGaz
  • Locked
  • Question
Pair of 3com 8810 Core Chassis Switches - FREE TO GOOD HOME
Replies
0
Views
84
NYCCGaz
NYCCGaz

Part and Inventory Search

Sponsor

Back
Top