I can complete calls from a DID PRI into the Nortel CS1000 across a QSIG PRI to my ShoreTel 220T1A; however, when I try to call to the outside world across the QSIG PRI from the ShoreTel to the Nortel the Nortel is regecting the call with a cause code of #1 unassigned number. I do not have package QSIG-GF package 305 on the CS1000 just package 263. We want numbers displayed but not names. Any help?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
cannot complete calls from shoretel to nortel using qsig
- Thread starter voip64
- Start date
Did you setup the QSIG trunk group on the Shoretel side to prepend the outbound calls with a 9 or with your access code to diall out on the Nortel if it is not 9.
I have setup a couple of these and they usually go without a lot of BS. Were you able to configure the Nortel sides route and DCH as QSIG since you don't have that package?
I have setup a couple of these and they usually go without a lot of BS. Were you able to configure the Nortel sides route and DCH as QSIG since you don't have that package?
- Status
Similar threads
