I have a big problem and hope anyone can help.
There're 2 different subnets in 2 different locations. e.g. 10.1.1.0/24 and 176.1.1.0/24. The Checkpoint NG Feature Pack 3 is installed on 10.1.1.0 network. For the latter network, users will connect the SecureClient and connect to the former network. But once the SecureClient is connected and the policy loaded, the users can only browse the first network but cannot browse the existing one (176.1.1.0) without disable the policy. Thus, we have add 1 policy. When checking the source address is from 176.1.1.0/24, no encryption is needed and thus the users can browse both networks simultaneously even the policy is enabled. Everything is working fine. However, after we reboot the firewall, the users on 176.1.1.0 network cannot broswe the 10.1.1.0 anymore, even the authentication is successfully and the policy is loaded. Actually, we haven't changed any configuration on the firewall. Anyone have any idea on it?
Thanks very much if you can offer help!
There're 2 different subnets in 2 different locations. e.g. 10.1.1.0/24 and 176.1.1.0/24. The Checkpoint NG Feature Pack 3 is installed on 10.1.1.0 network. For the latter network, users will connect the SecureClient and connect to the former network. But once the SecureClient is connected and the policy loaded, the users can only browse the first network but cannot browse the existing one (176.1.1.0) without disable the policy. Thus, we have add 1 policy. When checking the source address is from 176.1.1.0/24, no encryption is needed and thus the users can browse both networks simultaneously even the policy is enabled. Everything is working fine. However, after we reboot the firewall, the users on 176.1.1.0 network cannot broswe the 10.1.1.0 anymore, even the authentication is successfully and the policy is loaded. Actually, we haven't changed any configuration on the firewall. Anyone have any idea on it?
Thanks very much if you can offer help!
