Cannot Access PDM

[monsterjta]

Hello,

I am attempting to connect to PDM on my PIX 515E, but cannot. I get a "Page cannot be displayed" error in IE6.

I am trying to connect to the inside interface. I am almost certain PDM is installed on the device. HTTP is enable on the inside interface.

Anyone have any suggestions? According to Cisco, the versions are well within spec to be able to use PDM.

Here is the sh ver output:

Cisco PIX Firewall Version 6.3(4)
Cisco PIX Device Manager Version 3.0(2)

Compiled on Fri 02-Jul-04 00:07 by morlee

procon-pix515e up 333 days 18 hours

Hardware:   PIX-515E, 128 MB RAM, CPU Pentium II 433 MHz
Flash E28F128J3 @ 0x300, 16MB
BIOS Flash AM29F400B @ 0xfffd8000, 32KB

Encryption hardware device : VAC+ (Crypto5823 revision 0x1)
0: ethernet0: address is 000f.8f38.6004, irq 10
1: ethernet1: address is 000f.8f38.6005, irq 11
2: ethernet2: address is 0002.b3ec.4570, irq 11
Licensed Features:
Failover:                    Enabled
VPN-DES:                     Enabled
VPN-3DES-AES:                Enabled
Maximum Physical Interfaces: 6
Maximum Interfaces:          10
Cut-through Proxy:           Enabled
Guards:                      Enabled
URL-filtering:               Enabled
Inside Hosts:                Unlimited
Throughput:                  Unlimited
IKE peers:                   Unlimited

This PIX has a Failover Only (FO) license.

 

[Supergrrover]

There can be two reasons
1. have you created the self signed cert for the pix?
2. you need to be using Microsoft Java (not Sun.) Google it for a download.


Brent
Systems Engineer / Consultant
CCNP, CCSP

 

[monsterjta]

Hm, interesting. I'll give that a try today and let you know how it goes. Thank you.