Can you use Site Administrator to connect to a G450 or G430 gateway? 2

[hunterrob]

I have seen and have connected to a G700 using Site Administrator but cannot figure out how to get it to work on a G430 or G450 gateway. Any help would be appreciated.

 

[AvayaTier3]

ssh port 22 and use root login / pw


A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"

bsh

40 years Bell, AT&T, Lucent, Avaya
Tier 3 for 30 years and counting
[URL unfurl="true"]http://bshtele.com[/url]

 

[hunterrob]

tried that and it did not connect

 

[AvayaTier3]

try

http://putty.org

download putty and install on your PC

Use putty, ssh, IP address of gateway, root login/pw

A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"

bsh

40 years Bell, AT&T, Lucent, Avaya
Tier 3 for 30 years and counting
[URL unfurl="true"]http://bshtele.com[/url]

 

[hunterrob]

I use Putty and Xshell already but I have been asked several times "can we use Site Admin. so I was trying to figure that out.

 

[lopes1211]

login to CM then go shell. from here, ssh into the gateway. works fine in ASA.

if you're trying to build a "generic device" in asa to connect directly to the g450, on the authentication screen you'll likely need to change the bulk cipher from AES to 3DES.

-CL

 

[AvayaTier3]

I used telnet port 23 with manual login to a g350
You first have to enable telnet in the g350

A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"

bsh

40 years Bell, AT&T, Lucent, Avaya
Tier 3 for 30 years and counting
[URL unfurl="true"]http://bshtele.com[/url]

 

[hunterrob]

changing the bulk cypher was the trick thank you!