For H323 extensions (not analogue sets), can you differentiate ring tone between DDI and hunt group?
E.G. extension 400, is a member of hungroup 'HG01'. Incoming route configured so calls into 1469 route to the hunt group. Plus an incoming route 1470 has been configured to route a DDI call direct to extension 400. Is it possible to configure the IP Office, so you can differentiate using the ring tones, whether the call is for the DDI or the huntgroup (rather than the display on the set)? How would you configure this?
I can see in the docs that you can configure analogue sets for different ring tones, however for H323 extensions, this does not appear you can; is that right?
Thanks in anticipation.
E.G. extension 400, is a member of hungroup 'HG01'. Incoming route configured so calls into 1469 route to the hunt group. Plus an incoming route 1470 has been configured to route a DDI call direct to extension 400. Is it possible to configure the IP Office, so you can differentiate using the ring tones, whether the call is for the DDI or the huntgroup (rather than the display on the set)? How would you configure this?
I can see in the docs that you can configure analogue sets for different ring tones, however for H323 extensions, this does not appear you can; is that right?
Thanks in anticipation.
