Hello:
I have a 2610 t1 connected to 512k point to point with another 2610. I can not ping or see the router. Here is the int #show interface serial0/0
Serial0/0 is up, line protocol is up
Hardware is PQUICC with Fractional T1 CSU/DSU
Internet address is 192.100.100.16/16
MTU 1500 bytes, BW 512 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation HDLC, loopback not set
Keepalive set (10 sec)
Last input never, output 00:00:01, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/1/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
314 input errors, 134 CRC, 103 frame, 0 overrun, 0 ignored, 77 abort
31864 packets output, 2002090 bytes, 0 underruns
0 output errors, 0 collisions, 8371 interface resets
0 output buffer failures, 0 output buffers swapped out
8 carrier transitions
DCD=up DSR=up DTR=up RTS=up CTS=up
serial 0/0 and service-module:
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state
to downodule
Module type is T1/fractional
Hardware revision is 0.104, Software revision is 0.2,
Image checksum is 0xED22BEC5, Protocol revision is 0.1
Receiver has no alarms.
Framing is ESF, Line Code is B8ZS, Current clock source is internal,
Fraction has 8 timeslots (64 Kbits/sec each), Net bandwidth is 512 Kbits/sec.
Last module self-test (done at startup): Passed
Last clearing of alarm counters 1d11h
loss of signal : 1, last occurred 1d10h
loss of frame : 2, last occurred 1d10h
AIS alarm : 0,
Remote alarm : 3, last occurred 09:36:51
Module access errors : 0,
Total Data (last 96 15 minute intervals):
7 Line Code Violations, 52 Path Code Violations
217 Slip Secs, 2 Fr Loss Secs, 1 Line Err Secs, 1 Degraded Mins
216 Errored Secs, 1 Bursty Err Secs, 2 Severely Err Secs, 0 Unavail Secs
Data in current interval (372 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
1d11h: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state
to up 4 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
4 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
I have a 2610 t1 connected to 512k point to point with another 2610. I can not ping or see the router. Here is the int #show interface serial0/0
Serial0/0 is up, line protocol is up
Hardware is PQUICC with Fractional T1 CSU/DSU
Internet address is 192.100.100.16/16
MTU 1500 bytes, BW 512 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation HDLC, loopback not set
Keepalive set (10 sec)
Last input never, output 00:00:01, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/1/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
314 input errors, 134 CRC, 103 frame, 0 overrun, 0 ignored, 77 abort
31864 packets output, 2002090 bytes, 0 underruns
0 output errors, 0 collisions, 8371 interface resets
0 output buffer failures, 0 output buffers swapped out
8 carrier transitions
DCD=up DSR=up DTR=up RTS=up CTS=up
serial 0/0 and service-module:
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state
to downodule
Module type is T1/fractional
Hardware revision is 0.104, Software revision is 0.2,
Image checksum is 0xED22BEC5, Protocol revision is 0.1
Receiver has no alarms.
Framing is ESF, Line Code is B8ZS, Current clock source is internal,
Fraction has 8 timeslots (64 Kbits/sec each), Net bandwidth is 512 Kbits/sec.
Last module self-test (done at startup): Passed
Last clearing of alarm counters 1d11h
loss of signal : 1, last occurred 1d10h
loss of frame : 2, last occurred 1d10h
AIS alarm : 0,
Remote alarm : 3, last occurred 09:36:51
Module access errors : 0,
Total Data (last 96 15 minute intervals):
7 Line Code Violations, 52 Path Code Violations
217 Slip Secs, 2 Fr Loss Secs, 1 Line Err Secs, 1 Degraded Mins
216 Errored Secs, 1 Bursty Err Secs, 2 Severely Err Secs, 0 Unavail Secs
Data in current interval (372 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
1d11h: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state
to up 4 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
4 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
