Can maintenance ports be refreshed?

[db277]

Hi, I am trying to identify all unused ports(Logical ID's) under: Maintenance/Port/Station/xxxx/Status. But when a phone has been plugged into the port and then unplugged the profile(set type) stays with the port untill another is plugged in(doesn't default to say "unequipped&quot. I'm wondering if there is a way to identify cross-connected ports with no sets, short of tracing all the wiring?
Thanxs.

 

[jinxs]

One thing I do is voice announce digital sets, if it goes right to coverage it is either a port with no set plugged in or DND is enabled. If you get a busy then the ext was not assigned coverage. Then again, it's either no set plugged in or DND is enabled. You just can't do this for T/R ports. If you have a magix 1.5 or later you can test the digital port but it sounds like you don't. Good luck.

 

[db277]

Thanks for trying "jinxs", it looks like there is no way of checking in programming without extensive tracing/testing, reason I am looking for this is I install these systems. A similar function to what I'm looking for, is "Port/DN Status" on a Nortel/Norstar. This function tells the user what DN is on the port and refreshes instantly.
Thanx

 

[TouchToneTommy]

This is just a shot, but if you do a board renumber, will it update the type of sets plugged into the ports?

 

[db277]

Even with a 'board renumber' or power cycle it still doesn't refresh the set status as "unequipped" it just leaves the last profile on, but thanks for the suggestion.