Hi Guys, I (still) have an Option 11c with 25.40b and no PRI packages and we want to see CLID on incoming calls. Trunks are all analog ground start. I posted this problem a while ago, and the consensus was that without a PRI package, there is no way to receive CLID on an analog trunk.
However, I read on another thread that the NT5D31 DXUT trunk card supports CLID on analog trunks. Is that accurate? Assuming I could get (import) an NT5D31, will it receive CLID and work with my PBX? Does the NT5D31 require specific software packages? Does it work with typical North American GS trunks?
I found a few surplus sites selling this card, but since it is several hundred dollars (even for a used card), I want some reasonable assurance it will work before I buy one. A few hundred dollars is still cheaper than the software upgrade (and voicemail upgrade) our vendor quoted us.
Nelson
However, I read on another thread that the NT5D31 DXUT trunk card supports CLID on analog trunks. Is that accurate? Assuming I could get (import) an NT5D31, will it receive CLID and work with my PBX? Does the NT5D31 require specific software packages? Does it work with typical North American GS trunks?
I found a few surplus sites selling this card, but since it is several hundred dollars (even for a used card), I want some reasonable assurance it will work before I buy one. A few hundred dollars is still cheaper than the software upgrade (and voicemail upgrade) our vendor quoted us.
Nelson
