Calls display H the the ext (ex. H2038)

[nortelfonguy]

When I call from on site to another site using 4 digits dialing across H.323 the number comes across with an H in front of the extension. I have the same problem on a T1 between sites. How can I fix this. Not service affecting just annoying.

 

[bigindian65]

I believe I have always seen that on "on-net" calls, never considered it annoying, unless CLID wasn't passed along with it.

 

[nortelfonguy]

Thanks for the comment bigindian. Do you know how to get rid of it.

 

[bigindian65]

maybe by changing the call type, you could test that. I'm not sure it will work, but by putting a DMI on the RLI that does nothing and only specifying CTYP has chgd CLID for me on-net, but I do not know about the effects on the H, test it out, try CDP call type first.

 

[MagnaRGP]

ld 16
chg
rdb
cust 0
rout <insert h.323 rt #>
enter until
isdn <enter Y>
enter to
ncna <enter y>
enter on through

 

[56BelAir]

The issue is you need to Program RCAP on your Virtual D channel in LD 17 the promt is (RCAP) enter (ND2) at both ends. This will also work for your PRI/ Tie lines D-channels. Hope this helps you should now recieve name display.

 

[fritzthecat]

Hello nortelfonguy,

check if plugin 14 is enabled if not enable it an try it again

go into pdt, do a plp 14, so you can see if it is enabled, if not, ple 13

regards
Fritz