-
2
- #1
wayne1234
Technical User
- Jun 4, 2008
- 1
I have read a lot of threads with this type of problem. They were all helpful, but did not have a resolution.
This is my resolution and hope will help others.
CS1000 Rls 5.5 on both sites and Single Callpilot rls 5
Have MGC for VOIP Trunking between sites
Use CDP to process calls
We installed a new CS1000 at a remote site and message lights did not work. Could not light the lights using MIK key at main site to confirm it was NOT a Callpilot problem.
Solution was in LD 15 Net_Data. VPNI and PNI not set properly. VPNI is the Node number and PNI should be same at both sites. Also verify in LD 16 in the Route under ISDN that the PNI is the same as the originating system.
This is my resolution and hope will help others.
CS1000 Rls 5.5 on both sites and Single Callpilot rls 5
Have MGC for VOIP Trunking between sites
Use CDP to process calls
We installed a new CS1000 at a remote site and message lights did not work. Could not light the lights using MIK key at main site to confirm it was NOT a Callpilot problem.
Solution was in LD 15 Net_Data. VPNI and PNI not set properly. VPNI is the Node number and PNI should be same at both sites. Also verify in LD 16 in the Route under ISDN that the PNI is the same as the originating system.