Callpilot mpu's no releasing

[csb8860]

I have a callpilot 4.0 on a 201i platform. When looking at the system monitor, and I make a call into the callpilot I will grab a channel and a mpu. When I hang up the call the channel will drop, But the mpu is held up for about 15 to 20 seconds. This is fine until very busy times in the system. We are having situations where there are several channels avaliable but no mpu's. Has anyone else run into this issue?

 

[a12ozbottle]

Are you using desktop fax or speech recognition. Both of these use more than one mpu, so when you see more mpus in use than channels this could be the case.

 

[Jeff325]

Csb8860

What you descibe is perfectly normal operation for MPUs, their is a delay in the dropping after a call as the reset themselves. If you are having issues with RNA on the CP you can always add additional MPUs to the CP.

Good Luck