Callmanager route pattern change

[rpma]

We are running callmanager 6.1 and use the 9 to connect to an outside line. Basically it is the Pre Dot in our rout patterns. Due to the fact that users make mistakes continually and dial 911 by mistake, I am looking to change to another number or the # key. After looking into what is needed to make the change I believe it is basically just changing the Route Patterns to reflect the new number or # key. So a route pattern of 9.(2-9)XXX… would now become #.(2-9)XXX… Also making sure that the number I choose or the # key is not used in any other location.
Am I missing something or is this really the bulk of the changes needed?

 

[Westi]

http://www.tek-tips.com/threadminder.cfm?pid=851

I have no clue about the call manager so I think you would be better off in the Cisco forum with the link above.

Joe W.

FHandw., ACSS

insanity is just a state of mind

 

[whykap]

As long as the # is not a used pattern already all you should have to do is change the route pattern from 9 to # as you described.
However you also need to make sure that any speed dials that users have are changed. Also speed dials on fax machines. In addition if you are using single number reach it will also have to be adjusted.
Same goes for click to dial, etc.

Finally you need to make sure that any peripherals integrated with call manager and use the call manager trunks are aware of that change otherwise outdial would stop. Peripherals can be voice mail, fax servers, meeting place, to name a few.