Calling Line ID Question

[MacMan11]

I just finished setting up a PRI in Canada and all is working well. The outstanding issue I would like to resolve is that when outbound calls are made, the DN of the extension making the call is being transmitted rather than our telephone number. I would like to find out how to transmit our main telephone number instead. There are so many variations pertaining to this in the NTPs it is difficult to pinpoint. One specific question refers to the PNI. I have seen references to not use 0. I have tried both 0 and 1 (in the NET_DATA and in the corresponding routes) but the output is always the DN. Does the PNI matter? In any case suggestions etc are gratefully accepted.

 

[johnpoole]

jump off or net data and read up on clid, build a clid table and the switch will xmit just that entry, if you need the prompts, let me know. it's simple if you have the book

john poole
bellsouth business
columbia,sc

 

[MacMan11]

Thanks John. I had just started to look at the NTPs on CLID stuff. Hopefully I can wade through it.

 

[johnpoole]

your right there's a lot of reading to go along with all that writing.. ha.. if you get stuck post again and i'll try to help

john poole
bellsouth business
columbia,sc

 

[9727279976]

Could you please tell me what SQWID/SCID/SQUID (not sure what the acronym is) stands for? I believe it has something to do with calling ID protocol.

thanks.

 

[johnpoole]

of i give, where are those prompts? here is a copy fo my clid


REQ: prt
TYPE: clid
CUST 0
SIZE 256
RNGE

INTL

ENTRY 0
HNTN 803
ESA_HLCL
ESA_INHN NO
ESA_APDN YES
HLCL 4348232
DIDN NO
HLOC 434
LSC 434

ENTRY 1
HNTN
ESA_HLCL 7000
ESA_INHN NO
ESA_APDN YES
HLCL 7000
DIDN NO
HLOC
LSC

ENTRY 5
HNTN 803
ESA_HLCL
ESA_INHN NO
ESA_APDN YES
HLCL 434
DIDN YES
HLOC
LSC


john poole
bellsouth business
columbia,sc