Calling and Called Line

[netwalker1]

Dear All :
How can I display the DID Number I am getting the Call on , and What is the DID Number I am using to call Outside ?

Also I need to get the FXO line which I got the call on ..


Mohamed Farid
[green]Know Me No Pain , No Me Know Pain !!![/green]
CCNP,CCSP,CCA,MCSE,MCSA

 

[andru67]

not really sure of your question but i'll try my best to lend a hand.

in the line settins for the device field on the device page, enter the name that you'd like to see displayed on called set. you are required to do this on all sets that in order to have the calling party name displayed to the called set.

are you seeking to have calls coming in from the c/o to route to a ip/ip softphone automatically? if yes, just config plar on your router to ring at the set you'd like to field call coming in from the c/o. bettr yet, use an auto attendant to allow customers options to reach the intended set.

Andru67

 

[netwalker1]

No ,, I have 3 FXO lines , and in the case of E1 fail , the Calls are routed through these FXO Lines ,,
I need to check what is the number I am using to dial from in these cases ,, is it the 1st FXO , or the 2nd ,, ???

Mohamed Farid
[green]Know Me No Pain , No Me Know Pain !!![/green]