CALLER ID

[jftg73]

I HAVE A MAIN NUMBER 12343000 BUT WHEN MY USERS CALLS TO OTHERS PHONES WITH CALLER ID ONLY REGISTER OUR MAIN NUMBER, HOW I CAN TO DO FOR ADD THE DN FORM MY USERS IN THE CALLER ID?

FOR EXAMPLE MY MAIN NUMBER IS 12343000 AND HAVE A DN 3324, AND I NEED THAT EXTERNAL PHONE WITH ID SHOW 12343324.

SOME IDEA? I LISTED THAT IS WITH CLID BUT HOW I SETUP?

THANKS.

 

[vztech]

LD 15

Req: chg
Type: NET_DATA
CLID:yes
Entry: 0
HNTN: your(npa)
HLCL: your (nxx)
DIDN: yes

 

[unkalary]

after you create the CLID table as vztech said, you will have to change the key on the phone to reflect the CLID table you created.

key 0 scr xxxx 0 with the last 0 being the clid table number

 

[coniglio]

unkalary, if I have one outbound route and I set CLEN to 0 to reference CLID 0 but then create a new CLID entry 1 and assign it to a phone, then which CLID table will be referenced on the far end's caller ID?

 

[unkalary]

CLEN is only used for non ISDN routes. Is your outbound route a PRI? If so the CLEN wont show up in the RDB. The clid tables are created in LD 15 under TYPE NET. Say yes to CLID and you can program the number of CLID table you need. Each phone number on the each phone has a CLID table associated with it(not a CLID for each number). That is the number sent over the PRI.
You can print the clid table in ld 21 and under TYPE just put CLID.
CLID tables are used for PRIs only. At least that is the way we do it here. You in the states or overseas?

 

[jftg73]

I SAW THAT IN MY PBX I HAVEN´T NPA AND NXX, MY PBX IS IN MEXICO CITY. IS CORRECT THIS IT?

 

[johnpoole]

a shortcut to npa and nxx is to put all 1st digits in a spn table, and it has two drawbacks, you can't restrict anything without an act of congress and your switch is a lot slower then it needs to be. this is true on either side of the border.

john poole
bellsouth business
columbia,sc