Caller ID

[Orim]

Hi friends,
I need a help. Our exchange md110 has connected to AXE10 via TLU76 (PRI ISDN). Our directory numbers are 2xx,3xx,4xx,5xx. The problem is whit outgoing calls. The caller ID information that B-number receive is 9171 200 instead of 9171 xxx. (For example – I am dialing from extension 230 - B-number receive ID information 9171200 , I am dialing from extension 300 - B-number receive the same ID information 9171200). In Number Analysis 200 is set as operator common DID series but I am not sure whether the digits 200 are sent from MD110 or are formed in AXE 10. The are no Number Conversations for outgoing and incoming calls.
Here are some print commands:
<RODDPEST=0;
EXTERNAL DESTINATION ROUTE DATA

DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE

0 12 000500000000025000 0 2 0

END

<ROCAP:ROU=12;
ROUTE CATEGORY DATA

ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP

12 711000001000 5 3101000000 0 30 128 00151515 510100000030 101111

END

<RODAP:ROU=12;
ROUTE DATA

ROU TYPE VARC VARI VARO FILTER RVA

12 SL60 H'00000300 H'15400000 H'06010020 NO H'000000

END

Where is the mistake? Is there are other important sets for this problem?

Thank you for all in advance!

 

[mduser]

Do you use the RONDI command, if not try to use it like:

RONDI:ROU=12,EXNOPU=0-9171;
RONDI:ROU=12,EXNOPU=1-9171;
RONDI:ROU=12,EXNOPU=2-9171;
RONDI:ROU=12,EXNOPU=3-9171;
RONDI:ROU=12,EXNOPU=4-9171;

You can set them all them if you want, its country depending if you have to. Mostly only 2-9171 will do.

Then you also have to look at the extension category settings. In the ADC there a bit concerning the 'Network affiliation' (in BC11 for digital extensions it's bit D10). It also controls the number displayed as YES or No to send the extension number. If not it will take the bundle number as it is programmed in the AXE. (in your case 9171200).

 

[Orim]

The ADC bit “network affiliation” is set correctly =1. EXNOPU was 2-9171 and 4-9171. I added 0-9171, and 3-9171 but the result is the same.