zodiacmindwarp6
Technical User
How do I set up caller ID on a Avay G3Si, or is this something the LEC has to provide, or both.. thanks for any assistance..
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Caller Id 1
- Thread starter zodiacmindwarp6
- Start date
- Status
DAVIDPAYNE
IS-IT--Management
If you are talking about the information you send out then it is both. You can normal control the number from this command.
change public-unknown-numbering
If it a name then that is the LEC.
change public-unknown-numbering
If it a name then that is the LEC.
-
1
- #3
your question is to vague.
Are you talking about CO trunks (POTS lines)? If so, that requires the service from the telco, and you need a TN429 to get the CID to work.
If you are talking about a PRI, then you need the public unknown numbering setup for outbound, and the telco to send you the data inbound, and there are some settings on the ISDN trunk group as well.
Mitch
Mitch
AVAYA Certified Expert
Are you talking about CO trunks (POTS lines)? If so, that requires the service from the telco, and you need a TN429 to get the CID to work.
If you are talking about a PRI, then you need the public unknown numbering setup for outbound, and the telco to send you the data inbound, and there are some settings on the ISDN trunk group as well.
Mitch
Mitch
AVAYA Certified Expert
- Thread starter
- #4
zodiacmindwarp6
Technical User
Would this help on incomming calls, or would i have to have that set up by the LEC
- Thread starter
- #5
zodiacmindwarp6
Technical User
Yes I was talking about Pots lines, Thanks for the heads up i will see about contacting them and ordering the TN429 card.. thanks again..
- Status
Similar threads
- Question