caller id problems

[grnichol]

I have a cisco call mamager tied to my CS1000 MG 5.0 with 2 qsig pri's. We have 2 pri's connecting the CS1000 to the pstn. When calls come to the nortel from the cisco the caller id and number are correct. When the cisco calls out to the pstn the caller id is being changed to the main number for the facility. On the following trace my cell phone shows 482-2345.

ACTIVE TN 021 01
ORIG TN 021 01 TIE RMBR 3 25 INCOMING TRUNK CALL
TERM TN 000 11 DID RMBR 7 11 OUTGOING TRUNK CALL
DIAL DN 98273138
MAIN_PM ESTD
TALKSLOT ORIG 25 TERM 25
EES_DATA:
NONE
QUEU NONE
CALL ID 812 15293
---- ISDN PRA CALL (ORIG) ----
CALL REF # = 16640
BEARER CAP = VOICE
HLC =
CALL STATE = 10 ACTIVE
CALLING NO = 4817906 NUM_PLAN:E164 TON:SUBSCRIBER ESN:NXX
CALLED NO = 98273138 NUM_PLAN:E164 TON:SUBSCRIBER ESN:NXX
---- ISDN PRA CALL (TERM) ----
CALL REF # = 11
BEARER CAP = VOICE
HLC =
CALL STATE = 10 ACTIVE
CALLING NO = 4817906 NUM_PLAN:E164 TON:UNKNOWN ESN:UNKNOWN
CALLED NO = 8273138 NUM_PLAN:E164 TON:SUBSCRIBER ESN:NXX
PDCA 1 PAD 0 0 PCML MU MU
PDCA 1 PAD 0 0 PCML MU MU

 

[johnpoole]

your programed to use clid entry 0.. if you make the qsig external that will stop and you'll carry the ldn of the cisco.. if you make entry 0 didn yes you will show the did of sets using the internal tie..

if you make entry 0 didn yes, any phone that is not a pldn did will have to be reprogramed off of clid table zero..

john poole
bellsouth business
columbia,sc

 

[grnichol]

How and where might i change that