Good morning all,
I have a LSP in Hong Kong. We are trying to get Caller-ID to display on 9620 IP phones. I am running CM 5.1. The trunks are setup correctly (I believe)... However, I am unable to display caller-id... I found the following thread690-1473268, but it was closed without a resolution. Our local provider was able to get CID using an analog set at the demarc, but S8300/G350 does not see it...
Running trace on TAC shows no caller info when set to Bellcore, NTT, and V23-Bell... Is there anyone out there that has experience with international caller-id setting?
Thanks in advance...
“Do not spoil what you have by desiring what you have not; remember that what you now have was once among the things you only hoped for.”
- Epicurus
I have a LSP in Hong Kong. We are trying to get Caller-ID to display on 9620 IP phones. I am running CM 5.1. The trunks are setup correctly (I believe)... However, I am unable to display caller-id... I found the following thread690-1473268, but it was closed without a resolution. Our local provider was able to get CID using an analog set at the demarc, but S8300/G350 does not see it...
Running trace on TAC shows no caller info when set to Bellcore, NTT, and V23-Bell... Is there anyone out there that has experience with international caller-id setting?
Thanks in advance...
“Do not spoil what you have by desiring what you have not; remember that what you now have was once among the things you only hoped for.”
- Epicurus