Caller ID in Co trunk

[eyal1975]

Hi All,

someone know how to configure Co trunk with Incoming caller id ?

My pstn provider send me the caller id information.
i saw in the document only 3 kinds of protocols "BELLCORE , NTT , V23-BELL " that supported in the u.s and japan.
is the S8300 Server rel 1.3 suuport incoming caller id for analog trunks ? and if it is please tell me what i should configure.

thanks alot

Eyal

 

[redphone]

This is what found:

The MM711 provides analog trunk and telephone features and functionality.


The MM711 provides the administrator with the capability to configure any of the eight ports of this analog circuit pack as:

A loop start or a ground start central office trunk
A wink start or a immediate start Analog Direct Inward Dialing (DID) trunk
A 2-wire analog Outgoing CAMA E911 trunk, for connectivity to the PSTN
MF signaling is supported for CAMA ports
Analog, tip/ring devices such as single-line telephones with or without LED message waiting indication
The MM711 also supports:

Type 1 and Type 2 Caller ID
Ring voltage generation for a variety of international frequencies and cadences
A hard-wired ground wire is added for each IROB-to-earth ground

 

[eyal1975]

Hi,
the type is co trunk loop start.
how to configure the caller id ?

eyal

 

[redphone]

Page 2 on the trunk group form should read:

Receive Analog Incoming CAll ID: Belcore

 

[eyal1975]

Hi,

this is the only administration i need to configure ?

Eyal

 

[TheMitelGuy]

What trunk card was used here?

Thanks
Neil

 

[dialtone]

How do you do this on an MM711 for DID? Can't set "Rec'v inc call id" to Bellcore, for DID group type, get an error msg...

=hang up & drive=

 

[jgideon]

Analog copper DID trunks cannot transmit CallerID signals. POTS callerID is only available on loop-start trunks (that I've ever seen).