Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Caller ID in a 2851 ISR

Status
Not open for further replies.
ayubaile

ayubaile

Technical User
Sep 2, 2006
10
Excusame, where can i get a document to make the configuration of CallerID in a VIC2-4FXO CARD for a CISCO 2851 ISR Router
 
Sort by date Sort by votes
FXO ports support inbound CID, FXS uses station-id....


[americanflag] SPC NVARNG
Tek-TIP Member 19,650
 
Upvote 0 Downvote
I don´t understand your answer, but if you refer to if the FXS has cid too the answer is yes
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

jarod_paris
  • Locked
  • Question
firmware for an AP2800 WiFi terminal
Replies
0
Views
154
jarod_paris
jarod_paris
PThomp3344
  • Locked
  • Question
Trying to connect to Cisco Unified Controller web interface: UC520W-16U-4FXO-K9
Replies
1
Views
186
bdk76
bdk76
stanlyn
  • Locked
  • Question
HowTo Install Multiple PAP2T ATA Devices on Same Lan
Replies
3
Views
181
iggsterman
iggsterman
Zero6
  • Locked
  • Question
question about cisco cbs 350-12xs 12 port 10g sfp+
Replies
0
Views
132
Zero6
Zero6
Willi DB
  • Locked
  • Question
Polycom410 Forward an incoming call
Replies
0
Views
78
Willi DB
Willi DB

Part and Inventory Search

Sponsor

Back
Top