Caller id forwarding

[enita]

Hello,
I have a Tda600 system that is connected by PRI30 links to telecom providers, and another PBX(at another site) connected through Qsig (PRI30).
On the port of the PRI30 connected to the providers i set the subscriber number and for local calls it is ok, but for the calls that are comming from the other PBX they are sent to providers with there calling number and not the one that i set on the port.
I want to modify the calling number that is sent from the other PBX to the telecom providers , is this possible?

 

[cwc3]

clip has to be set for each ext and be handled properly by the carrier.

 

[enita]

Yes this works.
But i have the calls from another PBX and there clip i want to modify before i send to the carrier.Now the calls from the other PBX are routed automaticaly by ARS to the carrier, they already have 9 prefix in the called number.
Theese calls clip i want to modify.

 

[cwc3]

Enita are you the on from Romainia?Have you tried using
tie table to strip digits?If not there must be a place in software to modify digits(strip or add) received by slave system.