Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
call status
- Thread starter alfalfa
- Start date
MattRutter
Vendor
Hi alfalfa..
Yes, I have this problem - twice!
Customer is using two 406V2s at 3.2(54). Both systems have old alchemy pot30 modules, but they are at 5.2(54) to match.
On both systems, no calls originating from the second unit show up on call status...
I have deleted the modules, and had the IPO re-discover them, but still the same.
The only thing I haven't tried is fully flattening the IPO...
I kind of assume that it's a bug in Call Status, not the switch, as call do show up in Monitor.
Now, if only I can persuade my customer to upgrade the alchemy units to IPO ones, V4 beckons!
Cheers, Matt
Yes, I have this problem - twice!
Customer is using two 406V2s at 3.2(54). Both systems have old alchemy pot30 modules, but they are at 5.2(54) to match.
On both systems, no calls originating from the second unit show up on call status...
I have deleted the modules, and had the IPO re-discover them, but still the same.
The only thing I haven't tried is fully flattening the IPO...
I kind of assume that it's a bug in Call Status, not the switch, as call do show up in Monitor.
Now, if only I can persuade my customer to upgrade the alchemy units to IPO ones, V4 beckons!
Cheers, Matt
- Status
